EMC Compliance offers extensive consulting services for both the design and testing phase of new product development. In addition, we can help existing products meet new and/or revised EMC requirements.

We can facilitate both on-site and off-site short-term consulting needs. Our staff can even join your testing at another faculty for expert on-the-spot troubleshooting. This can cut certification testing time considerably when minor failures occur, but testing cannot be reasonably rescheduled. Our engineers can pinpoint the cause of the failure and determine if "in-the-field" fixes are appropriate or if a redesign is warranted. Even if a redesign is required, the data gathered by our staff can help you correct the problems in the original design and minimized product delays.

The best time to institute EMI control is in the initial design phase, however financial considerations may prohibit full-time EMC personnel. Again, EMC Compliance can provide the expertise you need in a timely and economic manner. We can review your designs and point out possible trouble areas to be redesigned. If redesign is impractical, we can recommend EMI suppression techniques tailored to your specific product. You will enjoy the best of both worlds- minimal pay rolled technical specialists and competent EMC design.

Our staff is familiar with all common military, aerospace, automotive, and commercial EMC requirements and the subtleties in each particular test. A complete list can be found here.

All content on this page, unless otherwise noted, is the sole property of EMC Compliance. No part may be reprinted without written permission from EMC Compliance. For website suggestions and comments, contact webmaster@emccompliance.com